The Dam Plumber
← All posts

Drains & Sewer

What Is Hydro Jetting? Jetting vs. Snaking

November 11, 2026

Plumber sitting in a pickup bed next to a truck-mounted hydro jetter with its hose reels and pump

Hydro jetting comes up a lot when a drain keeps clogging. Here's what it is, how it's different from snaking a drain, and when it's the right call and when it isn't.

Hydro jetting is a drain cleaning method that sends high-pressure water through a pipe to scour grease, scale and roots off the walls. Snaking punches a hole through a clog; jetting cleans the whole line. The Dam Plumber in Boulder City, NV recommends it when the same line keeps clogging and the pipe is sound.

What is hydro jetting?

Hydro jetting is high-pressure water doing the cleaning. A hose goes down the line with a nozzle on the end that sprays water in every direction, so it scours the pipe from one end of the run to the other and flushes the loosened buildup out.

Our jetter is mounted on the truck, and we use it on homes and businesses around Boulder City, Henderson and Las Vegas. When it's done right, the pipe is about as open as it's going to get. Our hydro jetting service page covers the rest.

How is hydro jetting different from snaking a drain?

Snaking breaks through the clog. Hydro jetting cleans the pipe walls. Both are real tools, and most clogs only need the first one.

Snaking, which we call cabling, spins a steel cable down the line until it breaks through whatever is stopping the water. The drain runs again, but the grease or scale stuck to the pipe walls is still there. That's why some lines close back up a few weeks later.

Snaking compared with hydro jetting
Snaking (cabling)Hydro jetting
What it doesBreaks a path through the clogScours the whole pipe wall and flushes the line
Right tool forA one-time clogGrease, scale and roots that keep coming back
What's left behindBuildup still on the pipe wallsVery little; the buildup is flushed downstream
Old or damaged pipeUsually fineCamera the line first

If a regular drain cleaning clears your line and it stays clear, you don't need a jetter, and we'll tell you so.

When does a drain need hydro jetting instead of snaking?

When the same line keeps clogging after it's been cabled. That usually means something is coating the pipe, not just blocking it. These are the jobs where jetting earns its keep:

  • Kitchen and restaurant lines coated in grease
  • Scale built up inside older drains
  • Roots that grow back after the line is cabled
  • A main line that needs a full cleaning, not just a hole punched through
  • Commercial floor drains and floor sinks

Businesses feel this one the most. A grease line that backs up during business hours costs money. We came out of commercial plumbing before we started The Dam Plumber, so restaurant and building lines are familiar work. See commercial plumbing for the rest of what we do there.

Commercial floor sink backed up with gray water before the drain line was cleared

Is hydro jetting safe for old pipes?

Usually, yes, as long as the pipe is sound. If a pipe is already cracked, rotted through or collapsing, blasting water through it can make it worse.

That's why we often run a sewer camera inspection first on old cast iron or a line we haven't seen before, and you see what we see. If the pipe is solid, we jet it. If it's broken, jetting won't fix it. That's a sewer repair: we dig it up, cut out the bad section and put in new pipe.

Roots are the same story. Jetting cleans them out of the line, but it doesn't close the crack they grew in through. We wrote more about aging drain lines in why cast iron drains fail in older homes.

What happens on a hydro jetting job?

It's a short list. You know the plan and the price before any water goes down the line.

  1. We ask what's going on: which drains are slow, how often it happens and what's been tried.
  2. If the line is old or new to us, we put a camera down it first.
  3. We tell you whether we're cabling or jetting and give you the price before we start.
  4. We jet the line from end to end and flush it out.
  5. We run water to make sure it drains the way it should before we leave.

The bottom line

Snaking is the quick fix for a clog. Hydro jetting is the deep clean for a line that keeps clogging, as long as the pipe is sound, and a camera tells you whether it is. Nobody here works on commission, so we're not selling you a jetting job you don't need.

Same drain backing up again? Call us at 725-254-0089 or send a request.

Quick Answers

Is hydro jetting better than snaking?

Not always. Snaking is fine for most one-time clogs. Hydro jetting is better when a line keeps clogging because grease, scale or roots coat the pipe walls.

Can hydro jetting damage my pipes?

Not sound pipe. If a line is already cracked or rotted, jetting can make it worse, so we camera it first when we're not sure.

How much does hydro jetting cost?

It depends on the line, so we look at it and give you the price before we start. Most of the time that's the price you pay, but sometimes it's a different story behind the wall or under the dirt.

Does hydro jetting get rid of tree roots?

It cleans them out of the line, but it doesn't fix the crack they grew in through. If the pipe is broken, the roots will be back, and that calls for a sewer repair.

Do you hydro jet commercial lines?

Yes. We jet grease lines, floor drains, floor sinks and main lines for businesses, and we clean catch basins and storm drains too.

Can I get hydro jetting after hours?

Yes. We answer the phone 24/7, and we give you the after-hours rate before we head out.

Want Us to Take a Look?

Upfront price before we start. Nobody here works on commission.

Call 725-254-0089
Call 725-254-0089